Hello, and welcome back to Constantly Creating/The Little Whatnot Shop! I’m blog hopping with Stamp with Amy K’s Inkin’ Krew today, and our topic is “feminine.” That gives a lot of options for card creation (men being much harder to design for)!
This is really the story of two cards. I’ve been traveling and freelancing again lately, so I haven’t had a lot of time in the craft room. But before I left the state, I started thinking about several different cards I need to send, and I decided to use a flowery piece of the Share What You Love Specialty Designer Series Paper (DSP) as a background for all of them. (I confess, I was also hoping to meet a 4-6-card “use it up” challenge on a Facebook group by doing so. Ambitious for someone who hasn’t been home!)
Last week I cut three card fronts out of one 12×12 sheet of the DSP and still have a couple of scraps leftover for another smaller notecard yet—maybe a thank-you. Of the cards with the bigger sections, one will be for a belated birthday, another became a Mother’s Day card, and the friendship card I’ve used for today’s blog title will likely go to the local gift shop upon my next delivery. I love how the same piece of paper works for each type of card.
I’ve acquired a few off-brand things recently as well, so these cards are not entirely made up of Stampin’ Up products (as my demo status would prefer). But the bulk of them are SU, and you could easily substitute SU’s vases or flower stamps or another sentiment where I’ve placed mine; the design works regardless. I grabbed the “other” products because they were near me (read: not yet put away) and I’m always trying to use up my consumables. (Plus, I needed to finish a card quickly to be able to blog!) In the products list at the end of the post, I’ll add some Stampin’ Up product suggestions you could use to change this card into one of “theirs” entirely, alongside what I did use from SU’s line. 🙂
So, diving into the cards I’ve finished…I have to confess first that I began a card for friendship, forgot what I was doing with it, and turned it into the aforementioned Mother’s Day card. I had the sketchiest of ideas when I started pulling things together—which is probably why I got distracted and it became something else—but sometimes one just has to go with the creative flow. After I finished the Mother’s Day card, it was easier to just emulate the structure for the actual friendship card, only tweaking the materials. As the two are similar, I’ll show the Mother’s Day one here as well. In the pictures, you can see how the flowers and leaves in the Specialty DSP have a pearlized, translucent finish.
For both the blog card and the Mother’s Day card, I began with a Mossy Meadow card base of 80-lb cardstock in an A2 (4.25″ x 5.2″ finished) size, and I cut down the Crumb Cake background with shimmery Rich Razzleberry/Mossy Meadow flowered piece from the Share What You Love Specialty DSP to mostly cover the card front, with a little Mossy Meadow border showing all the way around. The Mother’s Day border is slightly larger than 1/8″, whereas the friendship border is slightly smaller than 1/8″.
The other day, I sat down with my Cuttlebug, my Stained Glass Thinlits and Stitched Labels Framelits die sets, and pieces of Rich Razzleberry cardstock and a random cardstock I ended up with in an order that reminds me a little of Crumb Cake. It is just a shade lighter, so it matches the Share What You Love paper quite well (and it’s another consumable I can use up! Yay!). I made off several die-cuts out of the cardstock and put them on the desk with the rest of my card pieces until I had more time.
On Monday, I tried several of them (unglued) with different flower stickers to see what I liked best together. The Mother’s Day card uses two Stitched Framelits, one of each color, layered together perpendicularly so that the lighter cardstock has a bit more weight to it on the busy background. The additional Rich Razzleberry die-cut seemed to ground the top one and give a fuller look even though I also liked the simplicity of only one Framelit.
For the friendship (“If friends were flowers, I’d pick you”) card, I had originally chosen the vase idea (before I forgot what I was doing) because I saw the sentiment and the vase/flower stickers about the same time, and they made sense to use together. Since I had used the Stitched Framelits on the first card, I used one of the Stained Glass Thinlits Dies for the second. I adhered some sticky adhesive to the back of the die-cut and replaced the square that comes loose when first cut, and then I backed both the “stained glass” piece and the solid square onto some Rich Razzleberry cardstock, using my micro-tip scissors to cut around the edges once they were stuck.
Note: Keep track of how the solid square comes out of the die; it’s not completely symmetrical, and there is a spacing difference when it’s turned the “other” way.
When I positioned the flower/vase sticker and temporarily placed the diagonal onto the DSP, I then felt it was too simple (story of my crafting life), so I cut down a couple of the gorgeous Pearlized Doilies and glued them to the back of the sides of the diagonal, which fluffed out the center in a similar style to the Mother’s Day card. I got three out of one doily the way I cut them, and the center circle is still able to be used for something else.
I wanted to make sure I left room for a sentiment across the bottom on both cards, so I tested the placement and figured out how big the border strip at the bottom would need to be. For the Mother’s Day card, I added 1/8″ above and below the sentiment ribbon I planned on using to darken the ribbon a bit and make it look more finished; then I cut some vellum adhesive to fit inside the ribbon and carefully merged the two. Ribbon is tricky to glue, the way it’s so flexible. It’s not my favorite way of doing it. I was going to wrap the edges behind the DSP, but because of where I’d trimmed the ribbon around the words on the next repetition, I didn’t end up having enough room to tuck it around. So I took pinking shears to the ends instead since regular scissors and a straight cut would cause it to fray.
The solid Mossy Meadow border for the sentiment on the friendship card is about 3/8″, though I didn’t measure. Because the letters are close together on the stamp, I was leery of using embossing powder or getting things too juicy in case they would blur or blend together. I fell back on some old Craft White pigment ink to stamp it, and then I heat embossed it, hoping it would turn slightly puffy but still be readable (I remember doing that once somehow, but since heating it this time did nothing except dry it, I’ll have to figure out the “puffy” process again). And then because I had room at the sides of the sentiment for geegaws, I trotted out my new Heart Epoxy Droplets and colored them with my Light Blackberry Bliss Stampin’ Blends alcohol marker, the way I’ve heard others have done. It actually works!
I’ve made the inside of both cards the same—white paper to stamp and write on, an old random wooden stamp sentiment that fits both types of cards, a little writing room, and a strip of Specialty DSP running along the bottom. And I used some retired heart epoxy sticker gems on the inside of the Mother’s Day card as well. Both cards flip up to open rather than right to left.
I also added DSP to the envelope flaps since the cards are the nicer sort.
Now that both are done, I might like the simpler Mother’s Day card better, though I do love the Stained Glass die. But I’m thinking I should have kept the doilies closer to the diagonal on the friendship card so the overall look wouldn’t spread out so much. Well, next time, I guess. The sentiment may be my favorite thing about them anyway, the way it uplifts and encourages the recipients. The older I get, the more I see how important it is to do that for others. Whose day can you brighten this week?
Thanks again for stopping by to read and say hello! The products I used or suggested will be at the very bottom of the post, after the linked list of hop participants. Clicking on any of the thumbnails will take you right to my online store if you see something you’d like to purchase.
We have a great group with much talent hopping with us today! Be sure to go to the other blogs and see what my team members have created too. 🙂 You can follow the linking list through each person on each blog you visit.
Karen Ksenzakovic: https://wp.me/paaNf4-wU
Mary Deatherage: https://wp.me/p5snyt-7OG
Jaimie Babarczy: https://wp.me/p79UhD-2E8
Shirley Gentry: https://stampinwithshirleyg.com/?p=4726
Julie Johnston: https://wp.me/p8SzmQ-2db
Terry Lynn Bright: http://tlsbrightspot.com/2019/04/09/country-floral-embossing-folder/
Sue Prather: https://wp.me/p5yitZ-17P
Amy Koenders: https://wp.me/p2SFwf-evn